Serviços Personalizados
Journal
Artigo
Indicadores
Citado por SciELO
Acessos
Links relacionados
Similares em
SciELO
Compartilhar
Revista de la Facultad de Ingeniería Universidad Central de Venezuela
versão impressa ISSN 0798-4065
Resumo
AGUDO, L et al. Tribological behavior of expanded austenite obtained by plasma nitriding of AISI 304 stainless steel. Rev. Fac. Ing. UCV [online]. 2005, vol.20, n.1, pp.71-76. ISSN 0798-4065.
Samples of AISI 304 stainless steel were nitrided during 30 and 40 minutes at a temperature of 400º C in a chamber, employing the incandescent discharge method. A pulsed DC source was employed, with 400 V and 100Hz, and a gaseous environment with a 1:4 N2-H2 ratio. For the plasma nitriding time of 30 min, a single phase of expanded austenite (S-phase) was obtained in the modified surface. For 40 min of exposure time, the presence of incipient Fe4N and CrN compounds in the more external zone of the surface was also observed. Using Scanning Electron Microscopy (SEM), the depth of the nitrided zone was examined. Both the microhardness tests on the nitrided surface and the SEM studies showed the same nitriding depth, ~24 µm, also the same for the two nitriding times. It was determined that the hardness for the S-phase, around 1500 HK0,025, is five times greater that the one for the steel without nitriding. Both the wear behavior and the friction features of the modified surfaces were studied by sliding wear tests under pin-on-disk configuration, at room temperature without lubrication, using AISI 52100 steel and alumina balls, respectively, as static counterparts. The balls used are of 6 mm in diameter. As additional parameters for the test, velocity of 0,1m.s-1, load of 5N and sliding distance of 1000 m were chosen. Using the AISI 52100 steel, the wear behavior mainly presents a combination of abrasion, adhesion and oxidation mechanisms, achieving a friction coefficient (µ) of 0.55 for all the tribological pairs. With alumina balls, only an abrasive wear mechanism for all the pairs was observed, and the respective friction coefficient was slightly greater than the first case, and equal to 0.6. For all the sliding wear tests, it is shown that the nitriding process improves the wear resistance of the stainless steel, because there is no significant difference between the loss in volume for each nitriding time.
Palavras-chave : ion-nitriding by incandescent discharge; expanded austenite; wear; pin-on-disk wear test; chromium nitride.











